AudioCodes Mediant 1000B - Figure 6-7: Clicking Module Title; Figure 6-8: Software-Removed Module; Figure 6-9: Captive Screws on Module

Mediant 1000B Gateway & E-SBC
Hardware Installation Manual 66 Document #: LTRT-41441
c. Click the title of the module that you want to replace; the Remove Module button
appears:
Figure 6-7: Clicking Module Title
d. Click the Remove Module button; a message box appears requesting you to
confirm module removal.
e. Click OK to confirm removal; after a few seconds, the module is software-
removed, the port status icons of the module turn gray and the name of the
module is suffixed with the word "Reserved":
Figure 6-8: Software-Removed Module
3. Disconnect all the cables from the module.
4. Physically remove the module from the slot:
a. Locate the two captive screws securing the module to the chassis:
Figure 6-9: Captive Screws on Module
b. Using a flathead screwdriver or your fingers, loosen the two captive screws.
c. Firmly grip the two captive screws and extract the module from the slot by pulling
the captive screw: