AudioCodes Mediant 1000B - Figure 6-15: Inserting HDMX Module into Slot; Figure 6-16: Pulling out and then Pushing in Handle on OSN Module

Hardware Installation Manual 6. Hardware Maintenance
Media Gateways & SBCs 71 Mediant 1000B Gateway & E-SBC
3. When the LED stops flashing and is constantly lit, indicating that the shutdown
sequence is complete, grip and gently pull the module's handle to slide the module out
of the slot.
4. Hold the new HDMX module in the correct orientation, as shown in the figure below,
and gently insert the module into the slot, sliding it along the slot's guide rails until it
makes contact with the card-edge connector located on the backplane.
Figure 6-15: Inserting HDMX Module into Slot
5. Push the HDMX module's handle until it clicks firmly into the slot.
6. On the OSN module, gently pull the module's handle until you hear two click sounds,
indicating that the handle has been fully pulled out, and then push the handle all the
way in again; the module undergoes a reset, indicated by the Hot Swap Blue
LED switching off.
Figure 6-16: Pulling Out and then Pushing In Handle on OSN Module