AudioCodes Mediant 1000B - Figure 4-2: Rear-Mounting Brackets Attached to Rear-Rack Posts (60 CM); Figure 4-3: Rear-Mounting Brackets Attached to Rear-Rack Posts (80 CM)

Hardware Installation Manual 4. Mounting the Device
Media Gateways & SBCs 33 Mediant 1000B Gateway & E-SBC
Warnings:
• At least two people are required to mount the device in the 19-inch rack.
• When attaching the device to the rack using the rear-mounting brackets, it is
mandatory to also attach the front-mounting brackets.
• To allow extraction and insertion of modules on the rear panel, make sure that the
distance between the rear panel and the rear rack posts is at least 580 mm. Thus,
card extraction can be done without disassembling the rear-mounting brackets.
Avertissements:
• Au moins deux personnes sont nécessaires pour monter l’appareil dans le bâti 19
pouces.
• En fixant l’appareil au bâti en utilisant des supports de montage arrière, il est
impératif de fixer également les supports de montage avant.
• Pour permettre l’extraction et l’insertion des modules sur le panneau arrière,
assurez-vous que la distance entre le panneau arrière et les montants arrière du bâti
soit d’au moins 580 mm. Ainsi, l’extraction de la carte pourra être effectuée sans
démonter les supports de montage arrière.
 To mount the device in a 19-inch rack with front- and rear-mounting brackets:
1. Open the Rear Mounting Bracket kit and remove its contents. Make sure that all the
items are included in the kit (see above).
2. Attach the two rear-mounting brackets to the two-rear rack posts, using two screws
(not supplied) per bracket. Make sure that you attach the brackets at the same height
level in the rack. See the figure below for correct orientation of the brackets when
attaching them to the posts.
Figure 4-2: Rear-Mounting Brackets Attached to Rear-Rack Posts (60 cm)
Figure 4-3: Rear-Mounting Brackets Attached to Rear-Rack Posts (80 cm)