Mediant 1000B Gateway & E-SBC
Hardware Installation Manual 38 Document #: LTRT-41441
9. Tighten the bolts on the front-mounting brackets.
10. With a Philips screwdriver, tighten the screws securing the rear-mounting flanges to
the rear-mounting brackets.
Notes:
• Make sure that all the mounting brackets are attached at the same level to the
mounting posts so that the chassis is supported in a horizontal position.
• If the depth of the rack exceeds the maximum length of the adjustable rear-mounting
brackets, install an additional side rack post to accommodate the length of the Rear-
Mounting Bracket.
To Next Page
Loading...
