AUMA AC 01.2 - Page 6

9710.3. Type of duty monitoring (motor starts and running time)
9910.4. Operating time monitoring
9910.5. Reaction monitoring
10010.6. Motion detector
10010.6.1. Activate motion detector
10010.6.2. Detection time dt
10110.6.3. Travel difference dx
10110.6.4. Delay time
10110.7. Monitoring of electronics power supply
10210.8. Temperature monitoring
10210.9. Heater system/heater monitoring
10310.10. Verification of sub-assemblies
10310.11. Phase failure monitoring
10410.12. Phase sequence detection and correction of the direction of rotation
10511. Functions: activate and enable.............................................................................................
10511.1. Functions: activate
10511.2. Functions: enable
10712. Product variants.....................................................................................................................
10712.1. Multiport valve
10712.1.1. Actuator type: set/check
10712.1.2. Gear reduction ratio: set/check
10812.1.3. Number of ports (positions)
10812.1.4. Home port (zero position): set
10912.1.5. Positions (of valve ports): define/check
10912.1.6. Operate to position via push buttons of the local controls
11112.1.7. Operate to position from Remote
11212.1.8. Dead band
11212.1.9. Correction of inertia
11212.1.10. Backlash compensation
11212.1.11. Signalling behaviour of positions: set/check
11312.1.12. Hysteresis for signalling intermediate positions: set
11413. Service functions...................................................................................................................
11413.1. Direction of rotation
11413.2. Factory setting
11513.3. Languages: reload
11513.4. Data export
11513.5. Data import
11613.6. Actual configuration: accept
11613.7. Firmware update
11613.8. Service software
11814. Diagnostics.............................................................................................................................
11814.1. Electronic device ID
11814.2. Bluetooth connection diagnostic
11914.3. Diagnostic Interface
12014.4. Position transmitter and potentiometer diagnostic
12014.5. Diagnostic Position transmitter RWG
12114.6. Diagnostic Position transmitter MWG
12114.7. Diagnostic Positioner
12114.8. Diagnostic On time monitoring
6
Actuator controls
Table of contents AC 01.2/ACExC 01.2 Profinet