AUMA AC 01.2 - Page 7

12214.9. Diagnostic Process controller
12214.10. Profinet interface: diagnostics
12214.10.1. Diagnostic
12214.11. Diagnostic FQM (fail safe)
12314.12. Simulation (inspection and test function)
12314.12.1. Actuator signals
12314.12.2. Interface signals
12515. Asset Management.................................................................................................................
12515.1. Operating data
12615.2. Event report
12715.3. Characteristics
12715.3.1. Torque-travel characteristic
12915.3.2. Position-time characteristic
13015.3.3. Temperature-time characteristic
13015.4. Histograms
13015.4.1. Motor running time-position (histogram)
13115.4.2. Motor running time-temperature (histogram)
13215.4.3. Motor running time-torque (histogram)
13215.5. Maintenance (information and signals)
13415.6. Operating times display
13415.7. Device temperature display
13516. Corrective action....................................................................................................................
13516.1. Primary fuses
13516.2. Fault indications and warning indications
14317. Appendix.................................................................................................................................
14317.1. Selection overview for output contacts and indication lights (digital outputs DOUT)
14717.2. Selection list of binary signals for digital inputs (DIN)
150Index........................................................................................................................................
154Parameter index.....................................................................................................................
7
Actuator controls
AC 01.2/ACExC 01.2 Profinet Table of contents