AUMA AC 01.2 - Page 5

769.2.3. Failure operation (reaction of the actuator) on loss of signal
779.2.4. Preset position: define
779.2.5. Failure position MPV: define
779.2.6. Delay time: set
779.3. EMERGENCY behaviour
789.3.1. EMERGENCY behaviour: activate
799.3.2. EMERGENCY failure reaction
799.3.3. Failure source (failure reason) for an EMERGENCY operation: set
809.3.4. Operation mode for EMERGENCY behaviour
809.3.5. EMERGENCY operation
809.3.6. EMERGENCY position
809.3.7. EMERGENCY position MPV
819.3.8. Torque switching: by-pass
819.3.9. Motor protection: by-pass
819.3.10. Stepping mode: by-pass
819.3.11. Operation profile: by-pass
829.3.12. Interlock: by-pass
829.3.13. Local stop: by-pass
829.3.14. Delay time for EMERGENCY operation
829.4. Enable local controls
839.4.1. Enabling function: activate
839.4.2. Enabling function behaviour
849.5. Priority REMOTE
859.5.1. Priority REMOTE: activate
859.5.2. Priority REMOTE behaviour
859.5.3. Fieldbus auto enable
859.6. Interlock (enabling operation commands)
869.6.1. Interlock: activate
869.6.2. Source of Interlock enable signal: set
879.6.3. Operation mode for interlock
879.6.4. Interlock behaviour (running direction)
879.7. Local Stop
879.7.1. Behaviour
889.8. EMERGENCY stop function
889.9. Partial Valve Stroke Test (PVST)
899.9.1. PVST activation
909.9.2. PVST source: set
909.9.3. Operation mode for PVST
909.9.4. Behaviour for PVST: define
909.9.5. Partial stroke for PVST: set
919.9.6. PVST monitoring time: set
919.9.7. PVST operating time: set
919.9.8. PVST reversing time: set
919.9.9. PVST reminder
929.10. Bluetooth interface can be activated and deactivated
9510. Monitoring functions .............................................................................................................
9510.1. Torque monitoring
9510.1.1. Torque by-pass
9610.1.2. Torque limitation of torque by-pass
9710.2. Motor protection monitoring (thermal monitoring)
5
Actuator controls
AC 01.2/ACExC 01.2 Profinet Table of contents