AUMA AC 01.2 User Manual

538.4.6. Hysteresis for positioner: set
538.4.7. Closing fully/opening fully (end position tolerance for setpoint)
538.4.8. Setting range: limit
548.4.9. Change-over between OPEN - CLOSE control and setpoint control
558.4.10. Input of setpoint position
558.4.11. Input range of setpoint position
568.4.12. Split Range operation
578.5. Process controller
588.5.1. Process controller activation
588.5.2. Process controller: set modulating behaviour
598.5.3. Setpoint source (input for process setpoint)
598.5.4. Behaviour on loss of process setpoint
598.5.5. Inverse operation
608.5.6. Internal process setpoint
608.5.7. Setting procedure
608.5.8. Proportional gain Kp: set
608.5.9. Reset time Ti: set
618.5.10. Rate time Td: set
618.5.11. Actual value source (input for actual process value)
618.6. Stepping mode
628.6.1. Stepping mode: activate
628.6.2. Operation mode for stepping mode
638.6.3. Start and end of stepping mode
638.6.4. On times and off times
638.7. Profinet addressing – device name assignment
648.8. Additional inputs for fieldbus
648.9. Combination of fieldbus-parallel interface
658.10. Auto change-over I/O (during fieldbus failure)
668.11. By-pass function
678.11.1. By-pass function: activate
688.11.2. By-pass application: configure
688.12. Lift Plug Valve (LPV)
708.12.1. LPV function: activate
708.12.2. LPV actuator type: configure
718.12.3. Delay time of LPV master actuator: configure
718.12.4. Delay time of LPV slave actuator: configure
718.13. Automatic deblocking
728.13.1. Automatic deblocking function: activate
728.13.2. Operation time for operation in opposite direction: set
728.13.3. Number of deblocking attempts: set
738.13.4. Tolerance range: set
738.14. Heater system and heaters
738.14.1. Heater system within the actuator controls
738.14.2. Heater on control unit (actuator)
748.14.3. Motor heater
759. Failure functions....................................................................................................................
759.1. Reversing prevention time
759.2. Failure behaviour on loss of signal
759.2.1. Failure reaction on loss of signal
769.2.2. Failure source (failure reason) for a failure operation: set
4
Actuator controls
Table of contents AC 01.2/ACExC 01.2 Profinet

AUMA AC 01.2 Specifications

General

Brand	AUMA
Model	AC 01.2
Category	Control Unit
Language	English