Automated Logic OptiFlex G5CE User Manual

OptiFlex™ BACnet Integrator (part no. G5CE) Automated Logic Proprietary and Confidential A Carrier Company. © 2022 Carrier.
Rev. 6/9/2022 All rights reserved.
46
Important changes to this document are listed below. Minor changes such as typographical or formatting
errors are not listed.
Date
Topic
Change description
Code*
What is the OptiFlex™ BACnet
Integrator (part #G5CE)?
Description now lists support for Rnet devices.
Picture of controller updated.
Port table/list includes Rnet.
4/22/20
Wiring for communications
Port S1/S2 baud rate for Modbus changed from 1.2 to
115.2 kpbs to 9.6 to 115.2 kbps
X-D
Troubleshooting > To revert to
default settings
New topic
X-PM-KC-E-TS
Adjusting driver properties >
BACnet Router Properties
Added autobaud information.
X-PM-KC-O
Addressing the G5CE > To set the
Port S2 address and baud rate
Added autobaud information.
X-PM-KC-O
Addressing the G5CE > To set the
Port S1 address and baud rate
Added autobaud information.
X-PM-KC-O
Addressing the G5CE > To set up
autobaud
New topic
X-PM-KC-O
To set up the controller through
the Service Port > Device tab
Added Data Backup and Restore.
X-PM-KC-O
To communicate through the
BACnet/IP Service Port network
New topic
X-PM-KC-O
To set up the controller through
the Service Port
Added ability to access WebCTRL® application or a
touchscreen device through BACnet/IP Service Port.
Corrected the static IP address settings.
X-PM-KC-O
To get the G5CE's serial number
A sticker is on the top of the controller and there is a
laser-etched number and QR code on the inside circuit
board.
X-PM-KC-O
What is the OptiFlex™ BACnet
Integrator (part #G5CE)?
Added BACnet/IP Service Port to the ports table.
X-D
10/1/19
Specifications
Updated BTL to Revision 14
X-PM-KC-O
3/7/19
What is the OptiFlex™ BACnet
Integrator (part #G5CE)?
Added Modbus to the ports table.
X-D
Specifications
To mount the G5CE
Changed Depth dimension from 7.09 cm to 5.31 cm.
Wiring for communications
Added "NOTE 4 is for future use" to footnote 1 below
table.
Driver
Added TouchScreen Schedule Edit Enable.
Changed description of BACnet third party integration
points capacity...
Added Modbus integration points capacity, etc.
BACnet Router Properties
Added Allow remote management of IP configuration.
BACnet firewall
Changed "controller from receiving" to "controller from
responding to".
Network Diagnostics - Statistics
Changed names of Trend links at the bottom of each
section.
Added Latency under Port S1 Statistics

Automated Logic OptiFlex G5CE Specifications

General

Brand	Automated Logic
Model	OptiFlex G5CE
Category	Network Hardware
Language	English