Introduction
Installation Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-INSTAL/DGB, Rev. C, 2016-29-02,
Autronica Fire and Security AS
Page 5
10.5 External Battery Cabinet ................................................................... 61
10.5.1Dimensions ............................................................................. 61
10.5.2Internal Connections in Battery Cabinet ................................. 63
11.Startup ............................................................................... 64
11.1 Power Up ........................................................................................... 64
12.Switches and Indicators on the Main Board .................. 66
12.1 Overview ........................................................................................... 66
12.2 Reset Switch (S1) .............................................................................. 66
12.3 Dip-switches for Mode Settings (S2) ................................................. 67
12.4 Battery Short-circuit Protection ......................................................... 67
12.5 Battery Restart after Deep Discharge (S3) ....................................... 68
12.6 Serial Port Settings (S4) .................................................................... 69
12.7 System Fault LED indicator (yellow) ................................................. 69
12.8 Status LED indicator (red) ................................................................. 69
12.9 Power LED indicator (green) ............................................................. 69
12.10Regulated 24V Indicator (green) ....................................................... 69
13.Exporting / Importing Configuration Data ...................... 70
13.1 USB Output ....................................................................................... 70
13.2 Entering the Service Menu ................................................................ 71
13.3 Exporting Configuration Data ............................................................ 73
13.4 Importing Configuration Data ............................................................ 73
13.5 Backup Current Configuration ........................................................... 74
13.6 Select Configuration & Restart System ............................................. 74
13.7 Save Configuration ............................................................................ 75
14.Changes on the Detection Loop ...................................... 76
14.1 Typical Scenarios .............................................................................. 76
14.2 Remove a unit and Insert the same unit ........................................... 76
14.3 Remove a unit and insert another unit of the same type .................. 77
14.4 Remove a unit and insert another unit of a different type ................. 77
14.5 Add a new unit to the detection loop ................................................. 78
14.6 Remove a loop unit from the detection loop ..................................... 78
14.7 Major Changes / Clear Loop Config. - Restart System ..................... 79
15.Changes on the Panel Bus ............................................... 80
15.1 Typical Scenarios .............................................................................. 80
15.2 Adding an extra panel to the Panel Bus ............................................ 80
15.3 Removing a panel from the Panel Bus ............................................. 81
15.4 Replacing a panel of the same type and with the same address ..... 81
15.5 Replacing a panel of the same type but with a different address ..... 82
15.6 Replacing a panel of a different type................................................. 82
16.Appendix ........................................................................... 83
16.1 Text Foils ........................................................................................... 83
To Next Page
Loading...
Need help?
General
