Maritime Installations
Installation Handbook, Autroprime Interactive Fire Detection System, 116-P-APRIME2-INSTAL/DGB, Rev. C, 2016-29-02,
Autronica Fire and Security AS
Page 56
10.2.3 Internal Wiring
The drawings in this chapter shows the internal wiring of the Fire
Alarm Control Panel BS-200M (cabinet) for the following
alternatives:
Cabinet with external BS-210 and no external panel bus
Cabinet with external BS-210 and an external panel bus
Cabinet with integrated BS-210 with or without external panel bus
– with mains changeover relay
Cabinet with integrated BS-210 with or without external panel bus -
without mains changeover relay
The following description applies to all alternatives:
K16 and K17 are connected to non-monitored input 1 and 2 on X3
for mains/energy fault indication. Inputs have to be configured to
show the correct fault text on the panel. If the power fault indication
is needed on external systems, 2 dedicated outputs can be
configured to be activated by non-monitored input 1 and 2 for
external power fault indication.
10.2.3.1 Cabinet with external BS-210 and no external panel
bus
To Next Page
Loading...
