Completing the power connection
Procedure
1. Plug one end of the H4DU 4-conductor coiled handset cord into the phone and the other
end into the handset.
2. Plug one end of the first Category 5 modular line cord into the Ethernet jack of the PC and
the other end into the secondary Ethernet jack on the phone, if appropriate.
3. For an IEEE-powered deskphone, plug one end of the second Category 5 modular line
cord into the Ethernet jack on the phone. Plug the other end of this cord into the Ethernet
wall jack.
4. For a locally powered deskphone, connect the Category 5 modular line cord provided with
the IP Phone Global Single Port PoE Injector GSPPOE-xx, where xx represents the model
number into the Ethernet jack on the phone. Plug the femite end of this cord into the
deskphone. Plug the other end of this cord into the GSPPOE-xx power injector jack labeled
DATA & POWER OUT. Plug another Category 5 cord into the GSPPOE-xx power injector
jack labeled DATA IN. Plug the other end of this cord into the Ethernet wall jack. Finally,
connect the GSPPOE-xx to an AC power source.
Installing a Dual Headset Adapter (DHA)
About this task
You can install a Dual Headset Adapter (DHA) on call center deskphones. The supervisor can
monitor calls in progress by attaching a DHA directly to a deskphone or to an attached button
module. The 9621G does not support a DHA.
Order the 9600 Dual Headset Adapter Kit (PK25) (Comcode 700500729), which includes dual
headset adapters and required cables for 25 deskphones.
Installing the Deskphone
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 23
Comments on this document? infodev@avaya.com
To Next Page
Loading...
