Task Steps
To change any of the IP
address values such as
Phone, Call Server, Router,
Mask, and File Server
Use the dial pad to enter the new IP address. IP addresses have
three sets of three digits followed by a period. Pressing star (*)
following entry of three digits causes a period to be placed in the
next position, and the cursor to advance one position to the right. If
you press the star (*) and enter an IPv6 address, a colon is inserted
into the input buffer and the cursor is moved to the next character
location. The exceptions are entry of a Router or Mask address,
which follows the IPv4 method of inserting a period rather than a
colon. For information on entry and validation of addresses in either
format, see Entering and validating IPv4 and IPv6 addresses on
page 40. For example, to enter the IP address 111.222.333.444 in
IPv4 format, press the number 1 on the dial pad three times then
press *, press the number 2 on the dial pad three times then press *,
press the 3 on the dial pad three times then press *, then press the 4
on the dial pad three times.
To enter an IP address in IPv6 format, use the dial pad in numeric-
only mode entry. Tap the desired dial pad key once for touch screen
phones, except for 2 and 3 which are alphanumeric. Use multi-tap
for touch screen phones. For example, pressing button 2 initially
enters a 2, followed by A, B, C, and back to 2. Pressing button 3
initially enters a 3, followed by D, E, F, and back to 3.
Proceed to the next step.
To change the 802.1Q
value
Use the Right navigation arrow to navigate through the text strings
corresponding to the L2Q values defined as Auto if L2Q=0, On if
L2Q=1, and Off if L2Q= 2 until the text string of the value you want
to change to displays. Proceed to the next step.
To change the VLAN ID
value
Use the dial pad to enter the new static VLAN ID of from 0 to 4094,
inclusive. Proceed to the next step.
To change the VLANTEST
value
Use the dial pad to enter the new value of the DHCPOFFER wait
period of from 0 to 999. Proceed to the next step.
4. Press Save to store the new setting and redisplay the Craft Procedures screen or Cancel
to return to the Craft Procedures screen without saving the value entered.
Once the new values are stored, the phone resets automatically.
Related links
Using local Administrative Menu procedures on page 36
Clearing the phone settings
About this task
Sometimes, you might want to remove all administered values, user-specified data, and option
settings and return a phone to its factory settings. You might have to remove all administered
values when you give a phone to a new, dedicated user and when the LOGOFF option is not
Using Local Administrative Menu procedures
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 46
Comments on this document? infodev@avaya.com
To Next Page
Loading...
