Note:
When SSH is manually enabled, the SSH port will only be opened for one SSH
connection. When that connection is terminated, the port will be closed, and it must be
reopened (SSH must be re-enabled) from the Craft Debug procedure if another
connection is to be established.
Related links
Using local Administrative Menu procedures on page 36
Changing Ethernet interface control
About this task
Note:
When updating Craft Procedures from a touch screen phone, tapping the line you want to
change or the applicable softkey produces the same result as selecting a line and pressing
the applicable softkey on a non-touch screen IP phone.
Use the following procedure to set or change the interface control value.
Procedure
1. When you select INT from the Craft Procedures screen, the phone displays the following
options with a prompt to use the Right and Left navigation arrows to select a setting:
Ethernet Choice Selector
PC Ethernet Choice Selector
The options that are displayed are the text strings associated with the current PHY1STAT
on the Ethernet line and the current PHY2STAT system value on the PC Ethernet line.
• Auto when PHY1STAT = 1
• 10 Mbps half when PHY1STAT = 2
• 10 Mbps full when PHY1STAT = 3
• 100 Mbps half when PHY1STAT = 4
• 100 Mbps full when PHY1STAT = 5
• 1000 Mbps full when PHY1STAT = 6
The PHY2STAT text strings are:
• Disabled when PHY2STAT = 0
• Auto when PHY2STAT = 1
• 10 Mbps half when PHY2STAT = 2
• 10 Mbps full when PHY2STAT = 3
Using local Administrative Menu procedures
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 49
Comments on this document? infodev@avaya.com
To Next Page
Loading...
