When you press the applicable button or key to backspace, the most recently entered digit
or period is erased from the display. The cursor remains in the erased character’s former
position.
5. Press Exit or tap the softkey for a touch screen deskphone to exit the local procedures.
Important:
If any changes were made using the 802.1X procedure or the ADDR procedure, if the
value of SIG was changed to SIP or if the Crafts Entry screen was invoked during
startup, the deskphone immediately resets when you press or touch Exit. If no 802.1X,
SIG, or ADDR changes were made, or if the local procedures were invoked post-
startup, the deskphone redisplays the screen or other display that was effective when
the craft options was invoked.
Note:
If PROCSTAT has been administered to 1, you will not be able to invoke any
administrative options other than VIEW.
Note:
Some touch screen deskphones present an onscreen keyboard with which you can
type the data that you want to enter on the display. See the applicable user guide for
information about using the onscreen keyboard.
Related links
Using local Administrative Menu procedures on page 36
Entering and validating IPv4 and IPv6 addresses
The dial pad uses numeric-only entry when an IPv4 address or the subnet mask is entered. On a
touch screen use a single tap. Use an asterisk to place a period within the address being entered.
When you press star (*) on the dial pad with the cursor in one of the three fields towards the left of
the display, the following happens:
• The field where you are trying to enter a value displays a zero if no value is entered.
• If you enter a valid value a period displays. The space after the field displays a period.
• The cursor moves to the next space.
When you press star (*) with the cursor in one of the three fields to the right side of the display, the
system beeps to inidicate an error and the cursor remains in the field to the right. Pressing the “*”
button while the cursor is in the last (right most) field results in an error beep and the cursor being
left where it is. If you enter all three dots that separate the fields and if the value of each field is
valid, the IPv4 address or subnet mask is complete.
The value of a given field might be invalid when you:
• Enter a digit that makes the value of the first field of an IPv4 address exceed 255.
Using Local Administrative Menu procedures
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 40
Comments on this document? infodev@avaya.com
To Next Page
Loading...
