• Warnings when NVLOGSTAT = 5
• Notices when NVLOGSTAT = 6
• Information when NVLOGSTAT = 7
• Debug when NVLOGSTAT = 8
2. To change the setting, press the Right or Left navigation arrow to navigate through the
settings.
Depending on the current value, the next sequential text string is selected and displayed
as the setting. For example, if the current value is Alerts (2), pressing the Right navigation
arrow changes the value to Critical (3). If the current value is Debug (8), pressing the Right
navigation arrow changes the value to Disabled (0).
3. Press Save to store the new setting and redisplay the Craft Local Procedure screen.
Related links
Using local Administrative Menu procedures on page 36
Logging off from the phone
About this task
Use the following procedure to log off from a phone.
Note:
If a user registered has logged in through a USB device, the following procedure is not
applicable. The only way to log off a phone registered with a USB device is by removing the
device.
Note:
When updating Local Craft Procedures from a touch screen phone, touching the line you want
to change or the applicable softkey produces the same result as selecting a line and pressing
the applicable softkey on a non-touch screen IP phone.
Caution:
Once you are logged off from a phone, you might need a password and extension to log back
in.
Procedure
1. When you select LOGOUT from the Local Craft Procedures screen, the phone displays the
following text:
Press Log Out again to confirm.
2. Press or tap Log Out to log off from the phone.
Press or tap Cancel to return to the Local Craft Procedures screen without logging off the
phone.
Using local Administrative Menu procedures
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 51
Comments on this document? infodev@avaya.com
To Next Page
Loading...
