• 100 Mbps half when PHY2STAT = 4
• 100 Mbps full when PHY2STAT = 5
• 1000 Mbps full when PHY2STAT = 6
2. To change the Ethernet setting, press the Right navigation arrow to navigate through the
possible settings.
Depending on the current value, the next sequential text string is selected and displayed
as the setting. For example, if the current value is 10 Mbps half (2) and if you press the
Right navigation arrow, the value changes to 10 Mbps full (3). If the current value is 1000
Mbps full (6) and if you press the navigation arrow, the value changes to Auto (1).
3. To change the PC Ethernet setting, select that line and press the Right navigation arrow to
navigate through the possible settings.
4. Press Save to store the new settings and redisplay theCraft Procedures screen.
Related links
Using local Administrative Menu procedures on page 36
Disabling and enabling event logging
About this task
Note:
When updating local Craft procedures from a touch screen deskphone, touching the line you
want to change or the applicable softkey produces the same result as selecting a line and
pressing the applicable softkey on a non-touch screen IP deskphone.
Use the following procedure to enable or disable logging of system events.
Procedure
1. When you select LOG from the Craft Local Procedure Screen, the deskphone prompts you
to use the Right and Left navigation arrows to select a setting and displays the following
text:
Log: text string Choice Selector
where the text string is the wording associated with the current system value of
NVLOGSTAT, defined as:
• Disabled when NVLOGSTAT = 0
• Emergencies when NVLOGSTAT = 1
• Alerts when NVLOGSTAT = 2
• Critical when NVLOGSTAT = 3
• Errors when NVLOGSTAT = 4
Using Local Administrative Menu procedures
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 50
Comments on this document? infodev@avaya.com
To Next Page
Loading...
