Changing SSON settings
About this task
Caution:
Do not perform this procedure if you are using static addressing. Perform this procedure only
if you are using DHCP and the LAN administrator instructs you to do this.
Note:
When updating Craft Procedures from a touch screen phone, touching the line you want to
change or the applicable softkey produces the same result as selecting a line and pressing
the applicable softkey on a non-touch screen IP phone.
Use the following procedure to set the Site-Specific Option Number (SSON).
Procedure
1. Select SSON from the Craft Procedures screen.
The phone displays the following text:
Current setting:
New Setting:
where the setting is the current system value of NVSSON.
2. To change the setting, use the dial pad to enter a valid SSON value between 128 and 255.
3. Press Save to store the new setting and redisplay the Craft Procedures screen.
Related links
Using local Administrative Menu procedures on page 36
Performing a self-test
About this task
Note:
9600 series IP deskphone stores two software code images in reprogrammable non-volatile
memory. The primary image, called the “big app” must be running to perform a self-test. The
backup image, called the “little app” does not support the self-test.
Note:
When updating localCraft Procedures from a touch screen deskphone, touching the line you
want to change or the applicable softkey produces the same result as selecting a line and
pressing the applicable softkey on a non-touch screen IP deskphone.
Use the following procedure to perform self-testing:
Using local Administrative Menu procedures
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 55
Comments on this document? infodev@avaya.com
To Next Page
Loading...
