Avaya 9608 - Setting or Changing the Signaling Protocol

To Next Page

To Previous Page

The completion of the restart procedure depends on the status of the boot and application

files.

Related links

Using local Administrative Menu procedures on page 36

Setting or changing the signaling protocol

About this task

Note:

When updating local Craft procedures from a touch screen deskphone, touching the line you

want to change or the applicable softkey produces the same result as selecting a line and

pressing the applicable softkey on a non-touch screen IP deskphone.

Use the following procedure to set or change the Signaling Protocol Identifier. A valid SIG Protocol

Identifier is either 0 (default), 1 (H.323), or 2 (SIP).

Note:

Perform this procedure only if the LAN Administrator instructs you to do so.

Procedure

1. Select SIG from the Craft Local Procedures screen. The deskphone prompts you to use

the Right and Left navigation arrows to select a setting and displays the following text:

Sig: text string Choice Selector

where the text string is the wording associated with the current system value of NVSIG,

defined as:

• Default when NVSIG = 0

• H.323 when NVSIG = 1

• SIP when NVSIG = 2

2. Press the Right or Left navigation arrow to navigate through the settings to change the

setting.

Depending on the current value, the next sequential text string is selected and displayed

as the setting. For example, if the current value is SIP (2), pressing the Right arrow

changes the value to 0 (default). If the current value is H.323 (1), pressing the Right arrow

changes the value to 2 (SIP).

3. Press Save to store the new setting and redisplay the Craft Procedures screen.

The remainder of this procedure depends on the status of the boot and application files.

Other manuals for Avaya 9608