The options that are displayed depend on the following parameters as set in the settings
file:
• Disabled if DOT1XSTAT = 0
• Unicast-only if DOT1XSTAT = 1
• Unicast/multicast if DOT1XSTAT = 2
The Pass-thru line is a text string associated with the current system value of DOT1X
where:
• Enabled mode if DOT1X = 0
• Enabled w/Logoff if DOT1X = 1
• Disabled if DOT1X = 2
2. Select the line you want to change.
Depending on which line you selected to change, the phone displays the following text:
Current setting:
New Setting:
3. To change the setting, press the Right or Left navigation arrow to navigate through the
applicable settings .
Depending on the current value, the deskphone selects the next sequential text string
displays it as the New setting. For example when you change the Pass-thru mode, if the
current value is Pass-thru mode, pressing the Choice Selector causes the deskphone to
display P-t w/Logoff. If the current setting is disabled, pressing the Choice Selector
changes the new setting to Pass-thru mode.
4. Press Save to store the new setting and redisplay the Craft Procedures screen.
Related links
Using local Administrative Menu procedures on page 36
Changing IP address information
About this task
Use this procedure to assign a static IP address to the deskphone.
Caution:
Static addressing is necessary when a DHCP server is unavailable. But static addressing has
room for text entry errors. So Avaya recommends that you install a DHCP server and do not
use static addressing.
Important:
IPv6 operation is limited to a specific customer set and is not for general use.
Using Local Administrative Menu procedures
March 2018 Installing and Maintaining Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP
Deskphones H.323 44
Comments on this document? infodev@avaya.com
To Next Page
Loading...
