104
Installing an Avaya SCC1 Media Gateway Stack
October 2002
7 At the rear of the media gateway, remove the two hole plugs from the bottom of the
media gateway. See ‘‘Media Gateway Earthquake Mounting — Rear View’’ on page
104.
8 Insert a pencil or marker through the holes in the bottom of the media gateway and mark
the floor directly beneath each hole.
9 Move the media gateway out of the way and drill a hole 0.5-inch (1.27 cm) in diameter
and 1.5 inches (3.8 cm) deep at the locations marked in Step 10.
10 Insert a concrete floor anchor (STARR part number 3425) into each hole.
11 Move the media gateway back into place and align with the Front Mounting Angle.
12 Attach the media gateway to the Front Mounting Angle using the four supplied #12-24 x
1/2-inch (1.27 cm) thread-forming screws. See ‘‘Front Mounting Angle Location’’ on
page 105.
13 Lay the supplied Stiffener on the bottom rear of the media gateway and align with the
holes in the bottom of the media gateway. See ‘‘Media Gateway Earthquake Mounting
— Rear View’’ on page 104.
14 Slide a nylon washer onto each of the two supplied long hex head bolts.
15 Insert the bolts through the Stiffener and thread into the concrete floor anchor. Tighten
securely.
Media Gateway Earthquake Mounting — Rear View
3
4
5
1
8
2
7
On
Off
On
Off
6
r781851a CJL 030796
To Next Page
Loading...
