Avery Dennison Monarch Tabletop Printer 1 - Recommended Cutter Operation; Setting the Backfeed

2-6 System Administrator’s Guide
Recommended Cutter Operation:
Printhead
Density
With
RFID
Supply
With
Stacker
Attached
Recommended Cut Modes
203
No
No
1, 2, 4 – Note: Cut Modes 3 and 5 may cause ribbon tearing
203
No Yes 1, 2, 4 – Note: Cut Modes 3 and 5 may cause ribbon tearing
203
RFID is not supported with 203 dpi
203
RFID is not supported with 203 dpi
300*
No No 1, 2, 3, 4, 5
300*
No
Yes
1, 2, 3, 4, 5
300*
Yes No 1, 2, 4
300*
Yes Yes 3, 5 – Note: Some RFID supplies may curl and cause a jam
(with cut mode 3). If this happens, use cut mode 1.
* Contact Service to order replacement 300 dpi printheads (KST) for use with the cutter and
RFID supplies.
Setting the Backfeed
Backfeed advances each printed label to the desired dispense position. Once that label is
removed, the next label to be printed is backed up underneath the printhead.
Select To
Off Disable backfeed.
On Enable backfeed. The printer moves the supply backwards before
printing. Use the Positioning menu to set the dispense position and the
backfeed distance.