Setting Defaults 6-3
Setting the Number of Decimal Places
Set the printer for 0, 1, 2, or 3 places after the decimal in a price field. In dollar currency,
you might print prices like this: $24.00 (2 decimal places) or like this: $24 (0 decimal
places).
Select To
0 Do not use decimal places.
prices print as whole numbers: $20
1 Print one place after the decimal.
prices print like this: $20.5
2 Print two places after the decimal.
prices print like this: $20.50
3 Print three places after the decimal.
prices print like this: $20.500
Setting the Slashed Zero Appearance
The slashed zero feature lets you select how you want the zero character printed; either
without a slash, 0 or, with a slash, Ø.
Standard or reduced fonts print the slashed zero character (Ø). Bold and OCR fonts print
the standard zero (0) only. The slashed zero selection does not take effect until the
format is sent to the printer again. If you change the way zero prints, you must resend
your formats.
Select To
No Do not print zeroes with a slash.
Yes Prints zeroes with a slash (Ø).
Setting the Power-Up Mode
Power-up mode lets you decide how your printer starts each time you turn it on:
♦ Ready to receive data and start printing (online mode).
♦ Operator can select a format to print (offline mode).
♦ Operator can enter data for a selected format using the 939i Keyboard or USB keypad
(offline mode). For offline data entry information, see the 939i Keyboard’s Operating
Instructions.
Select To
Online When the printer is turned on, you see “Ready.”
Offline When the printer is turned on, you see Data Entry mode. Make sure
formats are loaded into flash memory and a keyboard is connected if you
need to enter data.
To Next Page
Loading...
