Setting Defaults 6-9
Formatting Flash Memory
Before storing packets in flash memory, downloading a script, or updating the printer's
firmware, you must format the flash memory. Formatting flash memory is only
required once during initial printer setup.
Select To
No Does not format flash memory.
Yes Formats flash memory.
The printer's flash memory is cleared and reformatted. This process may
take several minutes. The printer reboots automatically after formatting
flash memory
Any scripts, downloaded fonts, formats, or graphics saved in the printer's
flash memory are deleted and must be resent to the printer.
Viewing Available Flash Memory
If you receive errors when downloading a script or other packets, make sure you have
enough flash memory available.
Select To
Unused Flash View the amount of available flash memory in bytes. Divide this number
by 1024 to get the number of available kilobytes. Make sure your font or
ADK script files do not exceed this amount.
Packing Flash Memory
Packing flash memory permanently removes any deleted files from memory.
Select To
No Does not pack flash memory.
Yes Packs flash memory.
Removes any deleted files from memory. Periodically select this option to
"clean up" the printer's memory.
To Next Page
Loading...
