7-2 Operator's Handbook
Viewing Script Information
You can view information about a loaded script.
Select To
Script Info View the information about the loaded script.
If a script is not loaded, you see "No script loaded."
If a script is loaded, you see the script name and version number.
Note: If a script is already loaded, see "Enabling a Script
," to continue. If you need to
download a script, see "Formatting Flash Memory" in Chapter 6.
Downloading a Script
Follow these instructions to download a script from the command prompt. Set the
communication parameters using the MODE command. Then, prepare the printer to
accept a script.
Select To
Load Script Prepares the printer to accept a script file.
Note: Only one script can be loaded in the printer at a time.
Send the script file to the printer.
When downloading a script, if you receive an error:
♦ Check the available flash memory. See "Checking Available Flash Memory" in
Chapter 6 for more information.
♦ Format flash memory. See "Formatting Flash Memory" in Chapter 6 for more
information.
After downloading a script, if the script does not appear to be loaded, try formatting flash
memory and download the script again.
Enabling a Script
The script must be enabled before you can use it.
Select To
No Does not enable the script. (Stop the script).
Yes Start the script. When you turn the printer off and back on, the script
automatically starts.
When you see “Ready,” the word “Script” appears in the upper
left-hand corner of the display.
Note: When a script is not loaded, this message appears:
To Next Page
Loading...
