Setting RFID Options 8-5
Using the Advanced Setup Menu
The preferred methods of RFID setup are:
1) Using the Easy Setup Menu to quickly configure the printer.
2) Using the Monarch® RFID Printer Setup Utility to configure the printer’s read/write
powers, positional settings, etc. Find this Web-based utility at
http://rbis.averydennison.com/en/home/products/printers/tabletop/ADTP1-product-
support-pc.html
The advanced setup menu is for advanced users. Changing settings in the advanced
menu is not typically recommended.
Note: Adjust these settings only if errors are received when using values from Easy
Setup or the RFID Printer Setup Utility. Adjusting these settings may cause
undesired results.
The advanced setup menu changes whether non-stop encode mode or stop-to-encode
mode is selected.
The Advanced Setup options include:
Option Choices Default Non-Stop
Encode
Stop-to-
Encode
Stop-To-Encode
Mode
Yes/No No X X
Singulate Mode Yes/No No X X
Write Power -15 to 23 -15 X X
Read Power -15 to 23 -15 X X
Encode Position 0 to 2000 0 X
Tag Saver Yes/No No X
First TID Position 0 to 2000 0 X
Start Encode Position 10 to 2000 100 X
Encode Zone 50 to 2000 200 X
Tag Verify None/Internal/
External/Both
None X X
Verify Power -15 to 23 -15 X X
Tag Verify Position 10 to 2000 100 X X
Retry Encode Enable/Disable Enable X X
Clear Data Yes/No No X X
Use the RFID Printer Setup Utility to calculate the required positional settings.
To Next Page
Loading...
