Setting Defaults 6-5
Using Flash Storage
Packets (formats, fonts, graphics) stored in flash memory are saved when the printer is
turned off.
Note: You must format flash memory before enabling this option. Formatting flash
memory is only required once during initial printer setup.
Select To
Disabled Does not allow flash storage.
Enabled Allows flash storage for formats, fonts, and graphics.
Setting the Image Error Mode
Image errors occur when there is a problem producing a complete label. Press ESCAPE
to clear an image error.
Select To
Disabled If a format does not print as expected, an error message appears on
the display.
Enabled If a format does not print as expected, no error message appears
and the format prints as is.
For example, bar codes require a non-print zone; if a bar code is
placed too close to the edge of the label, no error is reported and the
bar code may not scan properly.
Image errors include:
600 unable to image batch 614 portion of field off label
601 problem during imaging 615 invalid PDF417 bar code data
603 missing batch 618 invalid font size
611 invalid font, bar code or density 620 missing font data
612 missing batch data 621 invalid downloaded font
613 reference point off label 622 not enough font memory
Note: Error 616 (bar code dot shifting failed) is always reported.
To Next Page
Loading...
