Index-3
-S-
Sampling cycle time
•••••••••••••••••••••••••••11-1
Self-tuning function
••••••••••••••••••••••••••••8-4
Setup setting display
•••••••••••••••••••••••••••7-5
Simple configuration
•••••••••••••••••••••••••••2-1
Socket
•••••••••••••••••••••••••••••••••••••••••3-2
Socket mounting type
••••••••••••••••••1-2, 1-6, 3-2
Socket part
••••••••••••••••••••••••••••••••••••1-6
Soft cover
•••••••••••••••••••••••••••••••••1-3, 3-5
SP high/low limit
•••••••••••••••••••••••••••••5-14
SP high limit
•••••••••••••••••••••••••••••••••5-13
SP low limit
••••••••••••••••••••••••••••••••••5-14
SP setup
•••••••••••••••••••••••••••••••••••••••6-1
SSR
•••••••••••••••••••••••••••••••••••••••••••4-7
ST function
••••••••••••••••••••••••••••••••••••8-4
ST setting standby
••••••••••••••••••••••••••••5-18
Stable
••••••••••••••••••••••••••••••••••••••••
6-24
Stand-alone mounting
••••••••••••••••••••••••••3-2
Station address setup
••••••••••••••••••••••••••5-31
Stop bit setup
•••••••••••••••••••••••••••••••••
5-36
Stopper
•••••••••••••••••••••••••••••••••••3-2, 3-6
-T-
Terminal assignment label
••••••••••••••••••••••4-2
Terminal cover
••••••••••••••••••••••••••••1-3, 4-2
Terminal part
••••••••••••••••••••••••••••••••••1-6
Terminating resistor
•••••••••••••••••••4-2, 4-5, 4-6
Temperature unit setup
•••••••••••••••••••••••••5-4
Tightening torque
•••••••••••••••••••••••••••••11-3
Time proportional cycle time
••••••••••••••••••6-22
Transmission speed setup
••••••••••••••••••••••5-33
-U-
Upper display
•••••••••••••••••••••••••••••1-5, 2-2
User level setup
•••••••••••••••••••••••••••••••5-38
-V-
Voltage between terminals
••••••••••••••••••••••4-7
-W-
Waterproof mounting
•••••••••••••••••••••••••••3-3