Description
03|2022 EN 25
next to the Enter symbol must be pressed. Then a new cycle
opens. A speed must always be set in order for the filter pump to
switch on. N0 would correspond to “Stop”.
The device is delivered with summer/winter time switching. This
can be selected under “Options” in the control.
Setting the day
Proceed as follows to set the day:
1. Go to “Filter settings” in the menu tree.
2. Select “Edit day”.
3. Select the desired day with the and arrow keys.
4. Confirm with OK.
5. Set the time period in which the device is to filter with the
and arrow keys.
6. Confirm the time with OK.
7. Select the speed at which the pump is to run during the filter
period with the and arrow keys.
8. OK takes you back to the “Edit day” display.
9. Up to 5 time periods can be set per day.
Copy day
Proceed as follows to copy a set day to other days:
1. Go to “Filter settings” in the menu tree.
2. Select “Copy day”.
3. Select the day to be copied with the and arrow keys.
4. Confirm with OK.
5. Select the days to which the settings are to be copied with
the and arrow keys. Either a single day or the whole
week can be selected.
6. OK takes you back to the “Edit day” display.
7. The copy function can be used until all days have the correct
setting.
To Next Page
Loading...