R5906852 /09 F80136
3. Select Server and click OK.
Image 10–32
4. Enter the name or the IP address of the NTP server.
Tip: In case you cannot connect to an external NTP server although you can PING this server, the
connection is blocked by the local firewall policy. Contact your IT system administrator.
In case the connection is successful, a green icon appears at the right side of the server line.
5. Select Region and select with the arrow keys the region where the projector is installed.
Image 10–33
The list of cities is updated according the selected region.
6. Select City and select the city corresponding with your time line.
7. Select Apply to activate.
10.11 Power settings – Standby Mode (ECO mode)
Why change the power saving features?
As a power-saving feature, the projector will automatically go to ECO mode after 15 minutes. While in ECO
mode, it is no longer possible to use the OSD for anything other than a status overview.
If you want to be able to fully access the projector for a longer period of time, or want to reduce the time the
projector remains idle, it is best to change the power settings to your own personal preferences.
You can also fully disable these power-saving features all together, ensuring that all power state transitions
have to be done manually, or via remote commands (e.g. by using DMX).
GUI – System Settings
To Next Page
Loading...
Need help?
General
