R5906852 /09 F8060
6.3 Connector settings
About connector settings
The Connector Settings menu allows you to change settings for each input connector of the projector.
By default all options for every connector are set to automatic, together with the native Extended Display
Identification Data (EDID).
When entering the menu for each input connector, you can change the following:
• Color Space
• Signal Range
• EDID
How to configure a connector
1. Press Menu to activate the menus and select Source.
Image 6–5 Main menu, Source
2. Press OK.
The Select Source menu is displayed with the actual available sources filled out.
3. Scroll down to the bottom of the list of available sources and select Connector settings.
Image 6–6 Source menu, connector settings
The available input connectors are displayed.
Image 6–7 Example of the Connector settings menu
4. Select the desired connector.
The connector settings menu for the selected connector will be displayed.
GUI – Source
To Next Page
Loading...
Need help?
General
