R5906852 /09 F8032
Broadcast Address
Every projector has a broadcast (common) address '0' or '1'. The default address is '0'.
The choice between '0' and '1' can be selected in the GUI: “System Settings” → “Communication” →“IR
Control “.
Placing new batteries in the remote control or plugging the remote to a projector via a cable will
automatically reset the address back to its default value '0'.
2.12 Quick setup via Direct access
Quick source selection
1. Press the Input button on the remote control or local keypad.
Image 2–10
The Source selection menu opens on the LCD display.
Image 2–11 Example of the input selection menu
2. Use the arrow keys to select the desired source.
Quick test pattern selection
1. Press the Test pattern button on the remote control or local keypad.
Getting Started
To Next Page
Loading...
