Field Service Manual December 2003
Page 121 of 276
Replacing the motor :
The motor itself is installed in a tube which is connected to the filmdoor. All installed
above the drum-filmfeeder. Inside the tube a spring is wound up for giving extra
power so the motor is a bit relieved when opening the door. Before removing the tube
out of its holder don’t forget to lock the spring. There is a special tool(U shaped fork)
installed on the right side of the motortube which can be used for locking the spring.
If for one reason the spring has been unwinded it has to be wound up again in the
correct direction so it will help the motor when opening the door.
SilverWriter
Correct
upper stop
position
Correct
down stop
position
To Next Page
Loading...