Field Service Manual December 2003
Page 173 of 276
Installation of optic on carriage
Before positioning the optic on the carriage install three conic separaters between
the two. (this means that the optic is not directly resting on the carriage)
Separaters must be on those positions were the screws are installed to fix the
optics to the carriage.
Position the optic in such a way so the right rear corners of optic and carriage are
matching.
Fix the optic baseplate with three screws.
Install left(1) and right(2) guiding bars. For getting a more stable optic baseplate.
Fixing the screws: make them all first handtight. Then fix the vertical ones and
second the horizontal ones.
To Next Page
Loading...