Field Service Manual December 2003
Page 15 of 276
SilverWriter MF Site Preparation Checklist
Customer code:
Plotter type:
Customer contact 1:…………………….. Function: ……………………………...
Customer contact 2:…………………….. Function: ………………………………
Customer contact 3: …………………….. Function: ………………………………...
Customer contact 4: …………………….. Function: ………………………………
Installation address:
……………………………………………………………………………………..
……………………………………………………………………………………..
…………………………………………………………………………………..
………………………………………………………………………………………..
Plotter size: width=1725mm, depth=2358mm, min depth=1500mm, height=1825mm, service
height=2480mm, weight=1500 kg
Crate size:
width=2010mm, depth=2766mm, height=2079mm, 500 kg (2000 kg with plotter)
Has the customer received the pre-installation manual? Yes No
Does the customer have a storing place for the crate? Yes No If
no, plastic must be available to cover the crate
Forklift truck to unload plotter from truck (2000kg load, long blades) must be
available
Manual forklift (1500kg) must be available during installation
The entrance for the plotter and corresponding passageways or corridors
must be free from obstacles
Is the floor (including passageways) stable enough? Yes No
(install thick metal plates)
Does the floor of the plotter room need to be reinforced? Yes No
Will a film processor be online connected to the plotter? Yes No
The plotter room must be big enough (+1.5m space at drawer side, +1m
space at front and right side, 2.5m height)
Vibrations must comply with specs, in case of doubt contact specialized
company
Vacuum pump box must be installed in a dry and clean area (max temp 30°C)
outside the plotter room. 75dB , 2.7kW at 250mbar , 50
°C
Vacuum tube length to plotter → maximum 15m, outer ∅ = 72mm
minimum (supplied by Barco)
Vacuum pump box command cable connector ∅ = 35mm (supplied by
Barco)
To Next Page
Loading...