Field Service Manual December 2003
Page 35 of 276
Displays yoffset table (2048 points max) from nr (1 <= nr <= 2049).
Syntax: GETYSIZ
Loads the existing Ysize table in RAM memory
• Syntax: nr DISYSIZ
Displays ysize table (2048 points max) from nr (1 <= nr <= 2049)
• Syntax: GETPAR
Definition: Restore saved machine params
• Syntax: PROPAR
Definition: Store machine params in eeprom
• Syntax: PROYOFFS
PROYOFFS will save the new values of the Y-Offset table from the RAM of
the Maccon board into the EEPROMS on the Maccon board.
• Syntax: PROYSIZ
PROYSIZ will save the new values of the YSIZE table from the RAM of the
Maccon board into the EEPROMS on the Maccon board.
• Syntax: SECOR
Measures and corrects for eccentricity.
The eccentricity of the shaftencoder must be corrected. SECOR calculates this
automatically. To run SECOR, the drum must be spinning !
LTL > secor (example of secor on maccon)
Measuring .......... done.
SE events stored in trace buffer 0
counts: nominal=24414 average=24590 modulus=1487 (1ns)
min=24441 (-0.6059374%) max=24769 (0.7279382%)
Sinus in trcbuf 5
STORE SECOR IN RAM [Y/N] ?
STORE SECOR IN ROM [Y/N] ?
Check for stable average !
Check : Laser Tool Language Updates !
• Syntax: SHWPAR
Allows to show and modify the plotter parameters in the RAM of the Maccon.
LTL > SHWPAR
Parameter ver 3.2 your choice:
• Syntax: DUMPPAR
Dump all parameters to screen.
Added to LTL ‘m6v12s94’
Pump
• Syntax: 1 DRMVAC
DRMVAC eats a value (1/0) from TOS and turns the Vacuum Pump on/off.
• Syntax: 1 VACUUM
VACUUM eats a value (1/0) from TOS, enabling high vacuum in the drum.
To Next Page
Loading...