Barco SilverWriter 800 - Page 34

Field Service Manual December 2003
Page 34 of 276
CLRYTAB resets the table indices (pointers) to the beginning of the table.
This command must be executed before filling in the Y-SIZE or Y-OFFSET
correction tables.
• Syntax: CREYSIZ
CREYSIZ will prompt you for input of carriage position, correction etc...
Warning
DO NOT START WITH HRDWINIT ! You will be prompted as follows:
LTL > HRDWINIT
LTL > CREYSIZ
HRDWINIT not allowed
Example
Creating ysize table:
LTL > CREYSIZ
Number of input points : 2
CARPOS1 : 100e6
CORRECTION1 : 0
DELTA-CORRECTION1 : 1
CARPOS2 : 300e6
CORRECTION2 : 45
LTL > PROYSIZ
Storing parameters ...
Verifying ... OK.
LTL >
• Syntax: CREYOFFS
CREYOFFS will prompt you for input of carriage position, correction etc...
Warning
DO NOT START WITH HRDWINIT ! You will be prompted as follows:
LTL > HRDWINIT
...
LTL > CREYOFFS
HRDWINIT not allowed
Example
Creating yoffs table:
LTL > CREYOFFS
Number of input points : 3
CARPOS1 : 100e6
CORRECTION1 : 0
DELTA-CORRECTION1 : 1
CARPOS2 : 200e6
CORRECTION2 : 33
DELTA-CORRECTION1 : 1
CARPOS3 : 300e6
CORRECTION3 : 0
LTL > PROYOFFS
Storing parameters ...
Verifying ... OK.
LTL >
 Syntax: GETYOFFS
Loads the existing Yoffs table in RAM memory
• Syntax: nr DISYOFFS