Field Service Manual December 2003
Page 33 of 276
• Syntax: SKYMAX
Finds imax(maximum amount measured on the diode) for each beam between
min frequency and maximum frequency found during LOCKRANGE_ALL in
steps of 26. This should be in the region of 4000->4095
STORE SKYMAX VALUES IN ROM (Y/N) ? Y
If you answer NO to the previous question, the following question appears on
the screen
RESET and SAVE SKYMAX TO DEFAULT MAX. VALUES(Y/N) ?
answer N or tickoff to continue.
• Syntax: 3000 0 TNB
Used for auto optic tuning (using feedback diode).
TNB eats two numbers from TOS:
· the first number is the intensity setting (par.91)
· the second number is used for the shutter verify option
· 0 : SHINIT SHOPEN is executed, without shutter verify
· 1 : SHINIT SHOPEN is executed, with shutter verify
Syntax: defaults
Allows to set defaults for multibeam optics. This command will prompt you to
set (y/n) one or more defaults for options M, N, T, A, O, par.96 and the lock
range.
LTL > defaults
is it a drv4x3 [Y/N] ? y
upgrade M-table dcdbdv-->drv4x3 [Y/N] ?
Quality (0) or Speed (1) = 0
Defaults for RF-FREQUENCIES [Y/N] ?
depending on type of machine and base resolution
Defaults for beam-pin configuration [Y/N] ?
depending on type of machine
Defaults for thicknesses and ysizes [Y/N] ?
7 mil and 4 mil in option "T"
Defaults for DELAYS [Y/N] ?
depending on base resolution and default YSIZE
Defaults for TUCOR [Y/N] ?
TUCOR for all the beams is set on value 1000
Reset knife_corrections [Y/N] ?
Upgrade knife_corrections optics300-->600 [Y/N] ? n
Defaults for legal ppi [Y/N] ?
Defaults for lock range [Y/N] ?
Defaults for SKYMAX [Y/N] ?
Do not forget PROPAR if you want to store these values
Parameters
• Syntax: CLRYCOR
It is possible to clear the drum correction table with one command:
LTL > CLRYCOR
Clearing ysize table !!! ... Are you sure [Y/N] ?
Clearing yoffset table !!! ... Are you sure [Y/N] ?
• Syntax: COPYPAR
COPYPAR is used to copy LTL-parameters between 2Maccon boards.
Syntex: CLRYTAB
To Next Page
Loading...