Barco SilverWriter 800 - Drum Micro Master Parameter Table MM750

Field Service Manual December 2003
Page 97 of 276
Drum Micro Master Parameter Table MM750
 Warning:
All settings should only be entered by qualified personnel, paying particular attention
to the safety precautions and warnings.
MM750 : makes the drum spinning during exposure. Drumdirection: when standing
on the right of the SW(drummotor position) the drum spins clockwise during
exposure.
To enter the parameters into the Micro Master you have to use the three
buttons and the 4 digit LED display:
P
Use this button to toggle between parameter number and parameter
value.

Use the white button up to set parameter numbers and values to
higher values.

Use the white button down to set parameter numbers and values to
lower values.
P000 ==> P944 : Parameter numbers
0000 ==> 9999 : Parameter values
F000 ==> F154 : Fault codes
parameter: value remark explanation
-----------------------------------------------------------------------------------------------------
P001 : 0 displays the actual frequency into P000
P002 : 20 acceleration in seconds
P003 : 15 deceleration in seconds
P004 : 0 smoothing in seconds
P005 : 43 = frequency setpoint
P007 : 0 enables front panel buttons
P009 : 3 + to get access to the next set of parameters
P013 : 60 maximum motor frequency
P017 : 1 smoothing type
P018 : 1 automatic restart after fault
P051 : ? turns to the right
P052 : 5 selection control function
P061 : 4 brake active
P062 : 1 converter active (drum spinning)
P064 : 5 additional brake time in sec. (assure full stop)
P075 : 200 value of the brake resistor (Ohms)
P081 : 50 * motor nominal frequency (Hz)
P082 : 1410 * motor nominal speed (rpm)
P083 : 3.6 * motor nominal current (I)
P084 : 220 * motor nominal voltage (V)
P085 : 0.75 * motor nominal output (kW)
P086 : 150 motor current limit (%)
P087 : ? PTC enabled
P088 : 1 ! enables autocalibration (has to be done once)
P089 : x.x ! stator resistance (measured during calibration)
P122 : 0 disables forward/reverse button
= : This frequency should give you a certain drum speed.