Field Service Manual December 2003
Page 163 of 276
17 Scan window width (mil) : 32000
18 Nominal drum speed (rps) : 25000
19 Time out (ms) : 60000
20 Rule to winding offset : 1076905
21 Diagnostics level : 513
<CR> to continue
22 Tune diode pos (1/6400 mil) : 312230000
23 Machine identifier (B_options) : 51317166
24 Not in use : 0
25 Not in use : 0
26 Bplclk freq. (ppi) : 15000
27 Delayclk freq. (ppi) : 60000
28 Horizontal Offset (pixels) : 0
29 Vertical Offset (scanlines) : 0
71 Vac off time after load (ms) : 2000
74 Time out at drawer empty (ms) : 432000000
75 Minimum beams to expose : 1
87 R&D Pll Conf (0=off=default) : 0
88 Forced duty cycle(pix)(0=off) : 14
89 Ssipro software version : 45
90 Minimum flashing period (ns) : 200
91 ADC value for exp. (Cr Probe) : 1000
92 Gamma constant : 0
93 Obsolete : 0
94 Pitch and deltas : 0
95 Base resolution : 4000
96 Drum circumference (1/32 mil) : 934600
<CR> to continue
97 X linear correction (ppm) : 0
98 Y linear correction (ppm) : 0
99 SSipro3 enable 100% duty cycle : 1
Parameter ver 9.0 _ Your choice : 4
4 Resolution (dpi) : 4000? 5080
Parameter ver 9.0 _ Your choice :
4 Resolution (dpi) : 5080
Beams in use : 12
88 Forced duty cycle(pix)(0=off) : 11
91 ADC value for exp. (Cr Probe) : 1200
Parameter ver 9.0 _ Your choice : 4
4 Resolution (dpi) : 5080? 10160
Parameter ver 9.0 _ Your choice :
4 Resolution (dpi) : 10160
Beams in use : 12
88 Forced duty cycle(pix)(0=off) : 5
91 ADC value for exp. (Cr Probe) : 500
Parameter ver 9.0 _ Your choice : 4
4 Resolution (dpi) : 10160? 16256
Parameter ver 9.0 _ Your choice :
To Next Page
Loading...