Field Service Manual December 2003
Page 219 of 276
Remark:
When the installation is finished and the PC has been rebooted ‘ripmanager.exe’
and ‘barco.exe’ should run again in the processes of the Windows Task
Manager. ‘Barco.exe’ will only run if the license file (c:\rip\flexlm\license.dat)
is running and the network cable is installed. ‘Hotidl’ should also run again(in
processes of the Windows Task Manager) if Earlier than S3935 (AMCC chip)
was selected during the upgrade-installation.
At the end of Upgrade- Installation be sure that:
Resource files are back installed: C:\rip\rdbg\powerrip.res
pr_film.res
pr_recorder.res
License file is back installed : C:\rip\flexlm\license.dat
Ucam.db is back installed : In home directory (seen with ‘c:\set’(dos))
Phifac driver installed and running
To Next Page
Loading...