Barco SilverWriter 800 - Page 22

Field Service Manual December 2003
Page 22 of 276
• SSIPRO: Serial sequencial input Parallel rotated output
-Delay: Ssipro [Bn,pos,delay] data
-Software
• PHIFAC : In PowerRip (PCI board, f=33Mhz) (Pci Hotlink InterFace
ACcelerator)
-Cable:Ssipro-Phifac about 7,5m/outside plotter 5m.( Hotlink
Cable(275mbits/s)) High speed serial cable.
-Loopbacktest on phifac. Loopbackconnector: Sub-D:male 9P:4-6
8-9
C:\rip\field\phifac\phi_loopback /n /fr=33 /loopctr=50
phi_loopback [/d=num] [/f=27|33] [/h] [/i] [/l=num] [/n] [/r=num] [/s] [/t=-1|0]
INFO: /d[masize]=num DMA write size (in bytes,
max=3200)
INFO: /f[req]=27|33 Set test frequency (default is 27 MHz)
INFO: /h[elp] Prints this message
INFO: /i[nteractive] Asks for confirmation after each test
INFO: /l[oopctr]=num Set number of loops (default is 5)
INFO: /n[oexternal] Do only internal loopback tests
INFO: /r[eadsize]=num DMA read size (in bytes,
max=dmasize)
INFO: /s[tatus] Print out status after each test
INFO: /t[race]=-1|0 Set trace level (default is -1)