Field Service Manual December 2003
Page 238 of 276
→
Don’t forget to set the job position on film to T,L(plotter zero point) in the
‘powerrip.res’ file for the selected filmtype.
• Execute the ‘.bat’ file and the machine will start exposing (if the plotter is
initialised).
•
Remark: When new parameters are found, do not forget to change them in the
parameterlist or resource files.
Explanation of parametersettings
Index
T / L
Par 6
ADC value for expose : …0.mpr paramlist
Increment
Nr of repetitions
Chart home pos
200e6
spoiler
300e6 100e6
To Next Page
Loading...