Field Service Manual December 2003
Page 250 of 276
Example: smartupl.powerrip.ripdir: \\powerrip\ripshare
smartupl.my_PowerRip.mountdir
Allows the PowerRip to find the files SmartPlot has prepared. The value of
upl.mountdir is a semicolon separated (;) list of local directories and their mount
point on the RIP host.
smartupl.my_PowerRip.mountdir:\\my_PowerRip\ripshare\;\\my_PowerRip\ripshare\
Example: Smartupl.powerrip.mountdir: \\powerrip\ripshare\;\\powerrip\ripshare\
smartupl.mdb_name
Before sending data to the plotter the layer information and corresponding plot
parameters are entered into a merge database. Once the information is entered into
this database layers can be resent to the plotter without having to be loaded into Ucam
again. This file is placed local on the Ucam station and must have the extension .mdb.
smartupl.mdb_name: c:\plotter\smartmerge.mdb
Test Communication PowerRip Ucam Station
You can test the communication between the PowerRip and the Ucam Station with
the following 2 tests from a DOS Prompt:
If the connection is ok then you get four lines feedback with Reply from the
PowerRip. (tralpd048 = name of PowerRip)
To Next Page
Loading...