Field Service Manual December 2003
Page 254 of 276
► Can always try a ‘0 srchwo’ again.
► PID parameters still correct ?
► Clean the measuring scale - Clean the head with air pressure.
► Is it happening during ‘tunig’ or ‘skymax’ performance.
‼ Check all carriage cables. Carriage touching something during
‘tuning’ or ‘skymax’.
► Check 10 zero ohm straps on linear motor.
► Try replacing linear scale or Maccon.
Error : No ramping
Carriage wants to start exposing(ramping) but for some reason he does not.
► Goes together with no reference counter started(ref counter not stopped).
‼ Maccon - LTLversion
‼ RSF encoder
Error : No ramping : brake mode = 0
Carriage wants to start exposing(ramping) but for some reason he does not.
►Just before he starts exposing he wants to open the shutter but it doesn’t
work.
‼ Check shutter on different carriage positions.
‼ Probably cable from Electronic rack to Carlass.
To Next Page
Loading...