Field Service Manual December 2003
Page 44 of 276
Mechanical.
2
1
Speed adjustment film bridge
Speed controller: pneumatic device to adjust the amount of pressure
Rotary actuator: Making a rotation by means off pressure
Adjust the speed of the film bridge.
1. Close both speed controllers and on the rotary actuator.
2. The upper speed controller of the rotary actuator controls the speed of the film
feed bridge coming down.
3. The lower speed controller of the rotary actuator controls the speed of the film
feed bridge going upwards. Whenever you change the speed of the film feed
bridge, you have to check it again putting the film feed bridge several times up
and down. Fine tune if necessary. Place the film feed bridge up with the command
“8 SFDREL” and lower it down again with the command “8 RFDREL”
Rotary
Actuator
Speed
Controller
To Next Page
Loading...