Field Service Manual December 2003
Page 57 of 276
62 Back rol pos after flm rel (0=off) :2015 ; 28 inch
This parameter is the position where the film rol is coming down after relaxing the
film.This second position is the end position of the film.It can be found with
the drumpos . command. Parameter 62 is for a 28 inch film around the drum.
63 Back rol pos after flm rel (0=off) : ; 27 inch
See explanation of parameter 62
64 Back rol pos after flm rel (0=off) : ; 26 inch
See explanation of parameter 62
65 Back rol pos after flm rel (0=off) : ; 25 inch
See explanation of parameter 62
66 Back rol pos after flm rel (0=off) : ; 24 inch
See explanation of parameter 62
67 Wait after loader back multiformat : 0
Not used
68 Drum vac release offst from ldpt 2 : -980 ;27 inch
This is a very important parameter if you use the option of vacuum releasing
after loading. This option is set to on if parameter 72 (Vac off time after load)
is not set to zero. This parameter sets the drum to a certain position so that the
vacuum can be released for a certain time without film dropping from the
drum.
For 27 inch the position of the drum is so that the end of the film(tail) is
holded by the yellow roller. At that position, the beginning of the film(spoiler)
is at the position of the suctioncaps.
69 Drum vac release offst from ldpt 3 : -980 ;24-25-26 inch
This is a very important parameter if you use the option of vacuum releasing
after loading. This option is set to on if parameter 73-85-86 (Vac off time after
load) is not set to zero. This parameter sets the drum to a certain position so
that the vacuum can be released for a certain time without film dropping from
the drum.
For 24-25-26 inch the position of the drum is so that the end of the film(tail)
lies as close as possible to the beginning of the unload table(or still holded by
the yellow roller if possible) without the chance that the end of the film is
moved away when the unload table comes down. At that position, the
beginning of the film(spoiler) is at the position of the suctioncaps.
For a 24 inch film Single Format SilverWriter the tail of the film must just be
held by the yellow roller. See also explanation of parameter 58.
To Next Page
Loading...