Field Service Manual December 2003
Page 63 of 276
Take-over action.
When the film bridge reaches upper position, the take-over cylinder is pushed towards
the take-over plate. After this the take-over cylinder hits the take-over plate, the
vacuum in the suction caps is switched off. The film cannot drop, because it is
sandwiched between the take-over plate and the take-over cylinder.
So this means that the film is kept in position by one point. Since the position of the
take-over cylinder is in the middle of the film, no movement of the film takes place.
Now the film is hold in place completely tensionless.
To Next Page
Loading...