Barco SP2K-S

To Next Page

To Previous Page

R5913197 /02 SP2K-S130

3. Lift up the cover and remove it (reference 2).

Projector covers

Main Page

Table of Contents5
Safety9
General Considerations10
Important Safety Instructions12
Product Safety Labels16
High Brightness Precautions: Hazard Distance18
HD for Fully Enclosed Projection Systems20
HD in Function of Modifying Optics21
Getting Started23
Installation Requirements24
Unpacking the Projector26
Initial Inspection31
Convention Projector Orientation32
Air Flow of the Projector33
Web Communicator34
Web Commander35
Exhaust Adapter (Optional)36
Installation Process37
Installation Process Overview38
Physical Installation Projector39
Positioning the SP2K-S40
Accessing the Power Connections43
Connecting the Projector with the Power Net44
Connecting a UPS with the Projector Electronics46
Installing Air Exhaust Adapter (Optional)49
Lenses & Lens Holder53
Available Lenses54
Lens Selection55
Installation of a Lens56
Lens Shift, Zoom & Focus58
Scheimpflug Introduction60
Scheimpflug Adjustment61
Input & Communication65
Introduction66
Cinema Controller of the Projector67
ICP-D (Integrated Cinema Processor - Direct)69
Icmp-X71
ICMP-X Introduction73
Icmp-X Hdd75
What Are the Possible HDD Swaps77
ICMP-X Communication and Input Ports79
ICMP-X Status Leds81
ICMP-X HDD Status Leds82
ICMP-X Device Certificate84
ICMP-X Configuration Via Web Communicator86
ICMP-X Reset87
Obtaining the ICMP-X Certificate88
Removing a HDD from the ICMP-X89
Installing a HDD into the ICMP-X90
Projector Power Cycle93
Explaining the Power States94
Switching the Projector on96
Switching the Projector off98
Connectivity101
Connecting to the Projector for the First Time102
Software Update103
Convergence107
Opening the Sealed Compartment108
Closing the Sealed Compartment110
Convergence Controls113
Converging the Blue Pattern Onto the Red Pattern115
Converging the Green Pattern Onto the Red Pattern117
Extenders for Control Knobs119
Color Calibration121
Calibration Process122
White Point Calibration123
Color Gamut Calibration125
Projector Covers127
Removal of the Left Side Cover128
Removal of the129
Removal of the Rear Filter Cover131
Removal of the Entire Rear Cover132
Removal of the Right Side Cover133
Removal of the Operator Side Cover134
Removal of the Top Cover135
Mounting the Top Cover136
Mounting the Operator Side Cover137
Mounting the Right Side Cover139
Mounting the Rear Cover140
Mounting the Rear Filter Cover141
Mounting the142
Mounting the Left Side Cover143
A Dimensions145
Dimensions of the Projector146
Dimensions of the Universal Pedestal147
Dimensions of the Flat-Packed Pedestal148
Glossary149
List of Tools151
Index153

Table of Contents

Related product manuals