R5913197 /02 SP2K-S26
2.2 Unpacking the projector
What you need to do?
Upon delivery, the projector is packed in a cardboard box upon a wooden pallet and secured with strapping
bands and buckle clips. Furthermore, to provide protection during transportation the projector is surrounded
with foam. Once the projector has arrived at the installation site it needs to be removed from the cardboard
box and wooden pallet in a safe manner, without damaging the projector.
After unpacking let the projector acclimatize to a room temperature between 10°C (50°F) and 35°C
(95°F). It is suggested to only start using the projector after having it stored for a minimum of 16
hours in its final location. Neglecting this may result in a failure in the start-up of the Light Processor
Unit.
Required tools
• Side cutter
• Knife
How to unpack the SP2K-S projector
1. Remove the strapping bands from the packaging. Use a cutting tool (e.g. side cutter, knife, etc.) to
carefully cut the straps.
2. Carefully cut open the tape sealing the top flaps of the box and open it.
Image 2–1
3. Remove the top plate.
4. Remove the safety manuals.
Note: All product manuals are online available on the Barco website.
Tip: Use the QR code on the package label or product label to download the product manuals.
Getting started
To Next Page
Loading...
Need help?
General
